View Cart
Bike Parking Solutions:
All Products
Commercial Racks
Custom Bike Racks
Bike Storage Lockers
Bike Shelters
Home & Garage Racks
Bollards
Products and Information for:
Architects
Contractors
Schools K-12
Colleges/Universities
Government
Property Managers
Small Businesses
Architects
Contractors
Schools K-12
Colleges/Universities
Government
Property Managers
Small Businesses
Bike Parking Resources
News and Press
Bike Parking Guide
Bike Advocacy
Security Resources
World of Bike Racks
Funky Bike Rack Gallery
Bike Haven
Complete installation instructions are also included in the PDF brochure download located in the upper right corner of this page.
1. Place the REAR PANEL in place and clamp it to the UPRIGHT SHORTS. Using the four ½” holes in the REAR PANEL as a guide, drill through both walls of the UPRIGHT SHORTS with a 3/8” drill bit.
2. Lay an UPRIGHT SHORT and UPRIGHT TALL on the ground parallel to each other and about 86” apart. Lay a ROOF MEMBER between the two uprights and attach with four ½” bolts (finger tight). Note that the open square in the middle of the ROOF MEMBER should be facing the top of the assembly.
Repeat this step for the other UPRIGHTS and ROOF MEMBER.
3. With the help of 2 assistants, stand both UPRIGHT ASSEMBLIES up, about 136” apart. Lift a ROOF MEMBER LONG into place and attach it with four ½” bolts (finger tight). Lift the remaining ROOF MEMBER LONG pieces into place and attach them with four ½” bolts each. If installing additional units, repeat step 3 until all framework is assembled.
Tighten all ½” bolts.
4. Place the initial ROOF PANEL at one end of the assembly. The panel should cover both openings at the top of the uprights. With a 3/16” drill bit, drill through the ROOF PANEL and ROOF MEMBER LONG in noted points. Rivet both holes.
You may want to clamp a wood 2x4 to both UPRIGHT SHORTS at the level of the ROOF panel, so that all the ROOF PANELS stay aligned with each other.
Place the next ROOF PANEL in place, drill where noted, and rivet. Repeat with the rest of the ROOF PANELS. ROOF PANELS should overlap by the noted amount. The last ROOF PANEL may overlap more.
5. Drill 3/8” holes in the ground at the four slotted holes in the UPRIGHTS and secure the UPRIGHTS with 3/8” wedge anchors. If adding side panels, continue to step 6.
