View Cart
Bike Parking Solutions:
All Products
Commercial Racks
Custom Bike Racks
Bike Storage Lockers
Bike Shelters
Home & Garage Racks
Bollards
Products and Information for:
Architects
Contractors
Schools K-12
Colleges/Universities
Government
Property Managers
Small Businesses
Architects
Contractors
Schools K-12
Colleges/Universities
Government
Property Managers
Small Businesses
Bike Parking Resources
News and Press
Bike Parking Guide
Bike Advocacy
Security Resources
World of Bike Racks
Funky Bike Rack Gallery
Cycle Stall
On-street Bike Parking
Tools Needed for Installation
Tape Measure Marker or Pencil Masonry Drill Bit Drill (Hammer drill recommended) Hammer Wrench 9/16”
Recommended Install Base Materials
Solid concrete is the best base material for installation. Ask your Dero Rack representative which anchor is appropriate for your application to ensure the proper anchors are shipped with your rack. Be sure nothing is underneath the base material that could be damaged by drilling.
Installation
Attach the Cycle Stall segments on street with the supplied 3/8” x 2.75” carriage bolts, and move assembled unit into place. 3/8” anchors are shipped with the rack. Place the rack in the desired location. Use a marker or pencil to outline the holes of the flange onto the base material. Drill the holes in accordance with the specifications shipped with the anchors. Make sure the holes are at least 6” away from any cracks in the base material.
Tamper Resistant Fasteners
The concrete spike is a permanent anchor. The top of the wedge anchor can also be pounded sideways after installation so that it cannot be removed. Other tamper resistant fasteners are also available for purchase. When using the special tamper resistant nuts, always set and first tighten the anchors. Once the rack is installed, replace two nuts from the bracket (opposite sides from each other) with the tamper resistant fastener. DO NOT OVERTIGHTEN the tamper resistant nut.
