Swerve Rack

Tools Needed for Installation

Level
Cement mixing tub
Shovel
Trowel
Hole coring machine with 4” bit
Access to water hose
Materials to build brace

Installing into Existing Sidewalk

Core holes no less than 3” diameter (4” recommended) and no less than 6” deep into sidewalk. Place Swerve Rack into hole making sure the rack is level. Fill hole with Por-Rok or epoxy grout. 33-36” of the Swerve Rack should remain above the surface. Make sure rack is level and held in place until the grout has completely set.

Sleeve Method:

1. Place corrosion resistant sleeve (min. 3” inside diameter) in sand pour bed in exact location where rack will be installed. Make sure top of sleeve is at same level as desired finished concrete surface. Fill sleeve with sand to keep it in place and prevent it from filling with concrete.
2. Pour concrete and allow to cure.
3. After appropriate cure time, dig out sand from sleeves and insert racks, making sure they are level and at the appropriate height. Pour in Por-Rok or epoxy grout and allow to set.