Ceiling Mount
Wall Mount
Floor Mount

---

Tools Needed for Installation
9/16” Wrench/Socket
3/4” Wrench/Socket
1/4” Drill Bit or 3/8” Masonry Drill Bit (depending on anchor type)
Tape Measure
Drill (Hammer Drill Recommended)
Hammer
Level
Saw for cutting track

Recommended Base Materials:
Note: if installing a ceiling mounted Track Rack, continue with the assembly by following the directions below. If installing a wall mounted or floor mounted model, assemble those units according to their instructions first.

Installation:
Before installing: Make sure the ceiling is strong enough to accommodate the rack fully loaded with bikes. Compare parts shipped with rack to the parts list on the previous page. Contact Dero if any parts are missing. Make sure the 96” Slotted Track will fit in your space. If necessary, cut the Slotted Track to the required length.

1. Mount Channel Trolley Supports in ceiling with appropriate anchors so that the centers of the brackets are 2 feet from each end of the 96” Slotted Track and 4 feet apart from each other.
2. Slide 96” Slotted Track through the Channel Trolley Supports so that the centers of the brackets are 2 feet from the end of the Slotted Track.
3. Secure the Channel Trolley Supports onto the 96” Slotted Track by tightening the Hex Head Cap Screws and Flange Nuts through the holes in the Channel Trolley Supports.
4. Hammer an End Cap into one end of the 96” Slotted Track.
5. Insert the Trolleys into the open end of the 96” Slotted Track.
6. Insert the hooks through the holes in the tabs that are hanging down from the Trolleys. Each hook length should be at least 3” different than the neighboring hook.
7. If no more Track Racks are going to be spliced together, hammer in another End Cap in the open end of the Slotted Track to close it up.
8. If splicing an additional length of track, slide the Splice Slotted Track over the last 6” of the 96” Slotted Track.